WIP contains billable work that has been submitted and approved but has not yet been billed. Project status does not determine whether the underlying work is still unbilled, although your firm's WIP settings determine which project rows appear in the grid.
What is included in WIP
A time entry reaches WIP after it has been:
- Submitted
- Approved, either by a reviewer or automatically when the firm does not use a separate approval step
- Marked as billable
- Dated on or before the Unbilled as of date
An expense must also be posted and approved where approval is required. It remains in WIP until it is billed or written off. A write-down is recorded when the work is billed for less than its WIP value; the full entry leaves WIP when that invoice is sent.
What is not included
The following work does not appear in WIP:
- Non-billable time
- Draft or unsubmitted time
- Submitted time that is still awaiting approval
- Time or expenses dated after the selected Unbilled as of date
Because of this, a person's total recorded hours and their contribution to WIP are different numbers. Use Timesheet or Reports when you need to review all effort, including non-billable time.
Billing state, not project state
Closing or completing a project does not bill or write off its unbilled work. By default, WIP shows active, open projects. A firm setting can also show non-open projects when they have non-zero Unbilled Time, Unbilled Expenses or Unapplied Progress.
A project with unbilled work may therefore stop appearing in the default grid when it becomes non-open even though the work still exists. Reopen it only if that matches your firm's project-status policy, or ask an administrator whether closed-project WIP is enabled.
How to interpret the Status column
The Status column describes the state of the project or engagement. It does not tell you whether its work has been billed.
Use these columns to understand the billing state instead:
- Last Invoice
- Last Unbilled WIP Date
- Unbilled Overall
- Current Draft Invoice
A project can therefore show a closed status while still carrying unbilled value. A project on an open draft is reserved: it cannot be added to a second draft, and Auto Generate skips it. New work can still post to WIP and must be added to the existing draft.
Why this matters at month end
WIP is a record of value the firm may invoice, not a complete record of work performed. Reviewing WIP alone can understate effort because non-billable hours remain outside this module.
Unbilled value on a finished project also does not age out automatically. It remains until someone invoices it or writes it off. Closed projects with a non-zero balance should therefore be reviewed as part of month-end cleanup.
Related
- How work enters and leaves WIP
- WIP amount calculations reference
- Troubleshoot unexpected WIP
- Create or add to a draft invoice from WIP